05 : Set Up Simulation Commands

Introduction

LTspice offers six types of simulation.

To run each simulation, each analysis parameter must be set.
Select “Project” -> “LTspice Linkage” from the top menu bar of Quadcept to display the LTspice Parameters dialog. Each parameter is the same as in LTspice, and those who have used LTspice will be familiar with these items. The parameters set here are retained on a per-project basis.

After setting the parameters, select the type of simulation you wish to run in LTspice from the “Simulation Type” menu at the bottom of the dialog and press “OK” to transfer the data to LTspice.

Translated with www.DeepL.com/Translator (free version)

Recommend

06 : Run a Simulation with LTspice Run a Simulation with LTspice After setting the simulation parameters, select the simulation you wish to run from the “Simulation Type” at the bottom of the …