Quadcept 10.10.4 Released

New Features

Common

• Replaced the software terms of use in accordance with the revision of the Terms of Service.
• Added the ability to retrieve and display lifecycle information through Digikey integration.

Fixed Issues

Common

• Fixed an issue where approved objects were displayed in the preview on the CCM Approval Request Detail dialog.
• Fixed an issue that slowed down the placement of CCM components.
• Fixed an issue where a component category would be set to “None” when a local component was saved to CCM using “Save As”.
• Fixed an issue where components that were not intended to be output to a BOM file were included in the BOM file when running Upload BOM to CBM.
• Fixed minor issues related to CCM integration.

Circuit Designer

• Fixed an issue where the NoMount attribute was not properly converted in the CR-5000SD conversion process.

PCB Designer

• Fixed an issue that caused an error in the export of reverse netlists when a certain type of copper text was present.
• Fixed an issue that could cause planes to be shaped incorrectly when creating clearance for arc-shaped objects.
• Fixed an issue where certain custom pads were not converted in the CR-5000BD conversion process.
• Fixed an issue where some characters were missing in the Vector-jp font.

Side Note

This version fixes issues that occurred in Quadcept 10.10.0. Please see the following release notes for the changes included in Quadcept 10.10.0.